Flanged In Cut 14ga 30 Degree
Nordfab 14 Gauge In-cut duct fittings are used to cut into existing lines of industrial ducting.
In-cuts are standard 30° or optional 45°.
Specify A and C diameter and end treatment. Priced by C diameter.
Rotational Angle Flanges retained vanstone lip is standard. If welded flanges required, clocking must be specified.
Saddle length and width = 3" all directions from Branch Tube C
• Available in Galvanized (as shown below)
• Available with QF ends in diameters up to 24", and other various end types
• Available with 45° angle
• Optional gauges 22, 20, 18, 16, 12 and 10